Tip-Up and Up-and-Over Garage Doors in Bronkhorstspruit

• One-piece steel or timber panel
• Counterbalance spring mechanism
• Motorisable with the right operator

A tip-up garage door swings out and up in one panel, running back into the roof space on a simple frame. It is a common door on the older Bronkhorstspruit houses and a genuinely sensible one on plots and farm buildings, because it is cheap, simple and needs no power at all.

Tip-up garage doors we supply in Bronkhorstspruit

• Steel tip-up doors in the traditional ribbed and panelled profiles.
• Aluminium tip-up doors where a lighter panel is wanted.
• Timber tip-up doors where the house calls for it.
• Single and double widths, on new or existing frames.

Why a simple door still makes sense out here

There is a real virtue in a door with almost nothing to go wrong on a property where the nearest repair is an hour away. A tip-up door has a frame, a panel and a pair of tension components, and it will keep working through dust and outages that stop more sophisticated doors. On the right opening we will recommend one over a motorised alternative.

Where a tip-up door does not work

It needs clear space in front of the opening, because the panel swings out before it lifts. If a vehicle parks close, or the apron falls away, a sectional or roll-up door is the better answer. On a machinery opening it is simply too wide a single panel to be practical, and we will say so.

Wind and single-panel doors

A tip-up panel is a large flat surface and this is open country. A gust catching a partly open door will bend the arms or twist the frame, so we fit stops and check the pivots after any wind damage rather than only straightening what shows.

Balance and safe operation

A tip-up door is held by tension on each side, and the balance is the whole safety story. An out-of-balance tip-up door is heavy to lift and can come down hard. We replace the tension components in matched pairs and set the balance so the door stays where you leave it.

Frames on older and owner-built garages

A tip-up door depends entirely on its frame being square and its pivots level. Replacing a panel on a frame that has moved will not fix a binding door, so we check the frame first, because a new panel on a twisted frame is money wasted.

Corrosion at the bottom edge

The bottom edge is where these doors die, and on a property where the apron is gravel and water sits after a storm it happens sooner. Where the rest of the panel is sound we can replace the bottom section and specify a better coating on the replacement.

What a tip-up garage door costs in Bronkhorstspruit

Usually the least expensive garage door for a given opening. Priced on width, panel material, finish, whether the frame is being replaced, automation and travel.